Hercules HWNAP-300 Especificaciones descargar pdf (Pagina 31)

HWNAP-300 Hercules Wireless N Access Point

Or, if you have chosen not to install the QuickAccess icon:

You must switch to "fixed IP address" mode:

1. Click Start/Control Panel. Double-click

Network Connections.

2. In the LAN or High-Speed Internet section,

right-click the icon corresponding to your

wireless network connection (or to the network

Bridge, if you have created one) and select

Properties.

3. In the General tab of the Wireless Network

Connection Properties window, scroll down the

list, and select and highlight the Internet

Protocol (TCP/IP) entry.

4. Click Properties, and select Use the following

IP address.

An IP address is a unique address assigned by the

modem-router to the computer. Each computer has

its own identity, via its IP address, allowing it to be

identified within the network. The access point's IP

address is 192.168.2.254 by default.

5. Enter an IP address in the same subnet range

(for example: 192.168.2.10).

6. Enter the subnet mask 255.255.255.0.

7. Click OK to close the windows, then exit the

Control Panel.

The modem-router will now assign this IP address to

your computer.

You are now at the door to enter WiFi Manager N, which you must open using a password.

- To open the door, enter the default password or enter your own password if you have already defined one

(for information on how to define your own password, please refer to chapter 3.2. Changing the WiFi

Manager N password!).

- Click Connection.

The password ensures that you are the only one who can access your WiFi Manager N interface, and

therefore your Hercules access point's settings. For this reason, it is important that you change the

password when using WiFi Manager N for the first time (see below).

User Manual – 31/94

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Sin comentarios

Hercules HWNAP-300 Especificaciones Pagina 31